Premier Mounts RTM-S Spécifications télécharger pdf (Page 8)

Page 8 Installation Instructions

RTM-S

For the two upper mounting points, the Griplate™ flat side must be facing up. For the two lower mounting points, the

Griplate™ flat side must be facing down.

IT WILL TAKE TWO PEOPLE TO COMPLETE THE NEXT INSTALLATION STEP.

Step 5. At this time, center the universal bracket bar and tighten the set screws that are located on the universal brackets.

Universal Mounting Bracket Assembly

Step 1. Place the universal bracket bar and the universal brackets on a flat surface.

Step 2. Slide the universal brackets onto the universal bracket bar (as shown below) with the set screws facing up. At this time, do

not tighten the set screws that are located on the universal bracket.

THE CONGFIGURATION THAT THE UNIVERSAL MOUNTING BRACKETS ARE IN ABOVE MUST RE-

MAIN THE SAME. ANY DEVIATION FROM THE LAYOUT ABOVE COULD AFFECT THE OPERATION

OF THE MOUNT.

Griplate™

Universal Bracket Bar

Griplate™

Set Screw

Universal Mounting Brackets

Step 3. Place the display on a soft, flat surface, face-down. Next, place the universal bracket assembly on the back of the display,

with the universal brackets resting directly over the display mounting points.

Step 4. Once the desired position has been determined, place the Griplate™ washers over each mounting point and secure them using

the appropriate hardware (see Page 4 and 5).

If you havean un-even mounting surface, or a recessed mounting point, place the appropriately sized nylon washer

between the display and the universal mounting brackets (page 5).

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Premier Mounts RTM-S Spécifications Page 8