Premier-mounts WMK-027 Manuel d'utilisateur télécharger pdf (Page 10)

Page 10 Installation Instructions

WMK-027

Base Box Installation

Base Box

M6 x 12mm Screws

Step 1. Raise the base box projector mount to the upper mounting bracket.

Step 2. Align the two (2; one each side) mounting holes.

Step 3. Using a screwdriver/security wrench, insert and tighten two (2) M6 x 12mm security head screws. Do not over tighten the

screws.

Step 4. Attach the projector to the base box, referring to the PDS-PLUS Installation Instructions for nal adjustments.

Please review the Operator’s Manual that

came packaged with the PDS-PLUS before

attaching the PDS-PLUS to the upper mounting

bracket.

Security Wrench

Projector Mount

Extension Arm Installation (Optional)

Step 1. Slide the extension arm into the open end of the WMK-027 (the front of the mount).

Step 2. Attach the upper mounting bracket directly to the extension using two (2) M6 x 12mm set screws (see page 8).

Step 3. Adjust length so that the center of the upper mounting bracket matches the throw distance calibration.

Step 4. Line up the mounting holes on the extension arm with the mounting slots on the WMK-027.

Step 5. Using a screwdriver, insert and tighten two (2) M6 x 12mm security head screws, 1/4” at washers and 1/4” nylon spacers.

Step 6. Attach the PDS-PLUS (see page 10).

M6 x 12

Security Screw

Security

Wrench

1/4” Flat

Washers

Upper

Mounting

Bracket

WMK-027

If the extension arm was purchased at a later date, the end cover must be removed prior to installing the extension arm.

Please see the Operator’s Manual to determine the correct throw distance (the distance from the projector to the screen)

must be determined prior to mounting the projector.

1/4” Nylon

Spacer

Extension Arm

1 2 ... 5 6 7 8 9 10 11 12 13

Pas de commentaire

Premier-mounts WMK-027 Manuel d'utilisateur Page 10